PDA

View Full Version : Measuring Penile VOLUME


Big Al
04-22-2009, 06:54 AM
Some men like to measure their penile volume. I highly suggest adopting this method because it's accurate and shows you that even small measureable gains can actually have a large impact on volume.

The penis is most similar in shape to a cylinder; and the way to measure cylindrical volume is length times pi [approximately 3.14] times radius squared [base area times height]. Because it's difficult to obtain an accurate measure of penile radius, we'll have to use a slightly different approach to measuring penile volume.

Take your average girth measurement (measure your thickest and thinnest points and divide that number by 2). *Then divide that number by 6.28. Now square that number and multiply it by 3.14. Multiply that number by length. The resulting product will give you an approximation of your penile volume.

*Girth divided by pi roughly equals diameter, and diameter divided by 2 equals radius.

Here's an excellent article on measuring volume along with a different formula for obtaining it: Penis Enlargement Gym - Measuring the whole picture: Volume (http://www.pegym.com/articles/articles-on-penis-enlargement-exercises/measuring-the-whole-picture-volume-181-306)

tomkat1
04-23-2009, 08:14 PM
Thanks Big Al,

I'm new to this forum, but but have been PE'ing for some time. I will try and give it a shot to see what kind of volume I come up with on the penile volume. I think it's a great motivator to see any results...

Big Al
04-26-2009, 10:43 AM
Thanks Big Al,

I'm new to this forum, but but have been PE'ing for some time. I will try and give it a shot to see what kind of volume I come up with on the penile volume. I think it's a great motivator to see any results...

You're welcome :)

JAYCEE
04-04-2010, 09:43 AM
I had wanted to take a volume reading before I started PEing. My plan was to warm up some non-toxic play dough and form it around the erect penis and make a mold. Then I wanted to fill the mold with hot wax to make wax model and use water displacement to make an exact volume measurement with the model.

I couldn't stay hard enough when I put the play dough on. Go figure.

I wish there were an easy way to make a wax model. I think that would be the best way to see gains over time.

anth1225
04-04-2010, 10:53 AM
Try viagra and clamping ;)