SG device too much?

[Xolotl]

So I posted a question about whether the results of this device were permanent or not. The question was raised because I read an independent review from GQ magazine where the reviewer said his penis returned to his original size after he stopped using it.

I was told that he didn't use the device for the amount of time specified in the instructions and therefore didn't cement his gains.

So I would have to use this thing for 6 months? I can tell you right now I do not, in any way want the 3 inch gain that this device says is possible.

That would give me a 10 inch cock, most the female opinions I have heard tell me the 8" is "bordering on scary" So that is where I set my goal.

I plan on aquireing this device at some point, however if my worst fears are realized I am afraid I there will be a story ion the internet of some pervert stalking cattle late at night because his penis is too large for most women.

[anth1225]

In any PE you must cement gains by doing them for 3 to 4 months after.

[Daz MN Support]

Hello,

I can honestly say it is very unlikely that you would gain 3 inches in length in just 6 months!!!

Most customer gain around an inch in this time frame.

So on that note, please leave the cattle alone!!! :D

If you have any questions about the device let me know and I will help you to the best of my ability.

Regards,

[Ben MN Support]

Customers who wish to experience gains of around 2-3 inches tend to have to use the device for longer than 6 months.

I hope this helps. :)

Regards,

[Xolotl]

Yeah that comes somewhat as a relief to me :)

Thanks

[Xolotl]

I've just ordered my SG extender, can;t wait to try it out, thanks.

[Ben MN Support]

You will love it!

Let us know how you get on with it.

Cheers,

[Xolotl]

How concerned should I be about the SG cutting off the circulation to the head of my penis? It's a bit distressing it felling the head get cold as I know blood flow if being cut off. I can only imagine it's normal I can't see how this can be avoided.

However I have a smaller head unfortunately so I am wondering if I am strapping it too tight because I don't have the mushroom cap to rely on to hold it in place.

[Ben MN Support]

Hello,

To avoid cutting off the blood circulation to the head of the penis I would suggest that you do the following:

* Remove the device once every 2 hours and gently massage the penis for 7-10 minutes to restore blood flow

* Perform the PenisHealth warm up exercises before wearing the device to increase blood flow to the penis

* Try padding out the penis with medical gauze (bandage) to provide extra comfort and grip - This will help as you will not have to pull the strap as tight as you currently are doing

I hope this helps.

Regards,

[Xolotl]

Okay I just need to know one thing.

Is it normal for the head of my dick to turn colors and feel cold?
If not I had best return the thing because I have tried everything and can't keep it on longer than 30 mins.

Any looser and it slips right off

[Xolotl]

Another question.

When wearing it should there be any tension? I have been trying to get the length correct however the best I have gotten has the extension rods at full length, the springs are not compressed at all.

I never thought this thing would be so complicated.

[Xolotl]

I think I have found the answer to my question.
No not good to have that loss of circulation.
However I have found a few threads addressing this issue so I'll try them.

Stay tuned

[Ben MN Support]

Hello,

Have you managed to find the answers to all of your questions?

If not, reply to this thread or PM me and I will try to assist you further.

Regards,

[Xolotl]

Dr. Scholls for the win!

I got some of those comfort gel insoles and cut a strip of this gel which I wrapped around me penis below the glans. The sponge comfort pad that comes with the SG went on over that.

No slippage, at least for the time being. I am going to have to figure something else out when I want to use it at the highest tension, because there was slippage when I tested that.

I managed to keep this on for an entire hour. Probably took 3 hours of fiddling and tinkering with it. Took a measurement afterward and found that I had gained almost 1/4" BPEL. When I checked again the next morning I was back to normal, but I was impressed being the first time using it.

I think SG should just include that gel strip with the package, it really makes a major difference.

I think I will still try to find one of those neoprene can cozies and experiment with that since I have heard so much about it. However for now, I think I am good to go.

[Xolotl]

Even better put the sponge on first then the gel.

[Xolotl]

Can;t wear it under my pants. I wear failt loose pants... but I have to wear a skirt while sitting down at this computer.

[Xolotl]

Woohoo! wore it for an hour straight. The last 5 mins were a bit harsh but I think I am getting more accustomed to it or something.

The Beer Koozie stuff was a failure, Dr. Scholls is #1. Can't wait to add my weekly gains to my signature tomorrow.

I should invest in a Utilikilt. At this rate I'll need to be able to go out with it on.

[Xolotl]

Okay I have a question now. I am also unsure of the tension settings.

I have been using my SG tensioned so that the fist line on the hex cylinders are just barely visible. However if I count them I think there should be one more that there isn't.

Have I been using this set at 900g?

Without one section inside the tubing there is no tension at all, so I am a bit confused.

This thread is starting to look like my very own SG journal.

[Xolotl]

It looks like I have started off on this at 900g. That could explain my initial difficulties. However I don't seem to be suffering any injury thank goodness.

There is really no lower setting though. The next hex piston is exposed when the springs are fully extended and providing no tension.

Any idea if this is right? Or did they send me the cheaper starter version?

[Ben MN Support]

Hello,

I have sent you a PM regarding this matter :)

Regards,

[Xolotl]

My new issue. I appears my penis must be more elastic than most. Which probably explains why my gains have been so good.

However I have to have the extender as short as possible to put it on and after an hour and a half, I have the threads showing as if it were time to add more rods.

The next day, same thing gotta screw everything down as short as possible and as I am wearing it I have to max it out.

[Xolotl]

I hae added a pair of the smallest rods. It's a little intense at the beginning but so far so good.

[Ben MN Support]

To be honest it does sound like you needed to add extension bars to the device.

The rule of thumb is to always make sure that the device is roughly 1cm longer than a fully out-stretched, non-erect penis before putting the device on.

I hope this helps.

Cheers,