Assembly

[REDGRAVE]

I just received the device and want to know where I place the springs. It's not clear in the instructions.

Thanks

Newbie

[llt8plus]

The springs are already in the device. Those springs in the bag are extra. Good luck wearing the traction device man!!!!!!!!!!!!

[REDGRAVE]

Thanks allot
I knew somthing wasn't right :sm33

[tractionman]

Maybe the extra springs aren't spare after all, but part of the kit if you're already hung like a horse NEIGH!!! :sm25

[tractionman]

You can't even use the wooden box as a cigar box, unless you can convince your guests that ANDRO-PENIS is an unknown brand of Cuban cigars.

On a serious note, every now and again, retighten the tube/spring/spacers because they tend to unscrew. Gives a new meaning to dropping nuts. Oh, the screw thread bits are only for locking the device in the upwards or downwards position when you are wearing clothing. Careful when you (if you) tighten them up as the skin can get caught in the thread (yes it hurts!). Also, when you compress the device to afix the loop to the glans, the telescopic assembly may well nick the skin on both sides of the shaft as it gives a nasty pinch. I've done it a few times now so I have first hand (pardon the pun) experience. Don't forget to lubricate the telescopic tubing lightly. Sewing machine silicon SPRAY is great for this. Spray the tubes OFF of the silicon loop bit otherwise you'll lose the grip all the time. I have found that when I fit the silicon tubing into their holders behind the 'head-rest', if I give a slight twist to the loop ends before I clip them into their tangs, then it tends to lock both loop ends in place.